In the processing of silicone products, screen printing is a very important process, in the process of manipulation to pay accurate attention to the appearance of silicone products are clean, pay attention to the screen printing after baking temperature and time, especially not to save money with low-quality screen printing ink and use other to replace, which will lead to the emergence of bad conditions, the quality of silicone products. In the end, the loss is not worth it! Huge losses to the enterprise. As screen printing can realize the character engraved in silicone products, screen printing this technology for silicone bracelets and other silicone products are very important, good screen printing level can improve the quality of the characters, but in the process of silicone products screen printing, will be flooded with characters will fall out of the situation, what is the reason!

Cushwa electronics to explain.

A, screen printing after the character a wipe off

Causes.

1. silicone products appearance is too dirty, impede the adsorption of screen printing ink and silicone, the formation of the character a wipe off.

Note: The amount of release agent used during molding should not be too high, and the surface should be kept clean during the subsequent processing and storage.

2. Screen printing after baking time or temperature is not enough

Attention: screen printing ink to completely cured solution: check the set temperature of the baking tunnel oven and tunnel oven alignment speed. Then check the tunnel oven, and the round wind

whether the machine is open.

3. The subject of screen printing ink

Note: You can not use the wrong ink <using silicone screen printing ink>

Second, the silicone products screen printed characters poor wear resistance

Expression: silkscreened silicone products characters through several uses, the characters gradually indistinct

Causes.

1. screen printing after baking time or low temperature

Note: the temperature and time difference between the baking scale value is too far, the temperature is too low

2. Screen printing ink quality is too poor

Note: The surface of silicone products can also be affected