Silicone products are recognized by consumers for their soft, non-toxic and environmentally friendly properties. At the same time, the mold industry also rises again and again with the heat of silicone. We all know that a good mold should meet the requirements of high manufacturing accuracy, long service life, short manufacturing cycle and low cost! But the problems in the manufacturing process make the accuracy and life of the mold greatly reduced, the following Cushion Electronics share with you some technical problems and corresponding solutions in the process of mold opening.

　　1. Size error.
　　The size of the mold does not meet the requirements, and the size of the mold made is small (large). The reasons for the error are: tool wear, human measurement size error, machine precision has been reduced. Common solutions: re-up the machine light size, processing to the standard size.
　　2. The workpiece is overcut.
　　Tool oversize, program overcut, improper operation of personnel can lead to workpiece overcut. The solution is to lower the surface to reopen, welding, inlay (make a gap of the same material inlaid into).
　　3 mold surface roughness.
　　The causes of surface roughness are the following: feed too fast (mold in and out too fast), tool wear, mold material can not meet the requirements. The solution to the above problem is to put the mold under the machine to save the mold polishing, replace the tool to achieve the corresponding precision, replace the mold material.
       Ltd. was founded in 2006, located in Longgang, Shenzhen, is a professional R & D, production and sales of high-tech enterprises. The company's main products include: heat-conductive silicone film, silicone keys, silicone feet, silicone kitchenware, silicone mats, silicone covers, silicone gifts and so on. Its products are widely used in daily life and electronic, automotive, communication, electrical appliances, automation equipment and other fields. If you need customized service, contact us: 0755-29832950