The installation of heat-conductive silicone film is simple, but to make it play its best role will have to pay attention to many details, the following Cushman & Wakefield Electronics will give you some advice on installation.

1, first of all, to keep the surface of the thermal conductive silicone gasket clean, not sticky dirt or dust, if there is dirt or dust, the first will increase the thermal resistance of the thermal conductive silicone gasket, thus reducing the thermal effect of the thermal conductive silicone gasket; the second will affect the self-adhesive and sealing of the thermal conductive silicone gasket, that is, and the degree of fit of the thermal interface, and the degree of fit is not high, it can not give full play to its role of heat dissipation.

2, when you need to use a large piece of thermal conductive silicone gasket, you must be especially careful, large area of the thermal conductive silicone gasket can not be taken with one hand (because the thermal conductive silicone gasket is very soft, one hand easily lead to deformation), you need to use both hands to hold, from the central part of the grab, the area of smaller can be directly gently grabbed by hand, and then gently paste on the interface. This step is very important, because if you just take just a sticker on the interface, it is easy to break the material, so it is not worth the loss, the material can not really play its role.

3, after tearing off one side of the release film, tear off that side, facing the radiator, the location of the thermal conductive silicone gasket aligned with the radiator, seamlessly laminated between the interface. Note that a point is to slowly put down, so as to avoid the generation of air bubbles. If air bubbles are generated after the operation, you can gently tear up a corner, pull up a little, and then slowly put down. You can also use tools to gently iron out the thermal conductive silicone gasket to wipe out the air bubbles, the force should not be too large to prevent the thermal conductive silicone gasket from being damaged.

4, the thermal conductive silicone gasket side onto the radiator after the hand gently tear off another layer of heavy release paper, but also pay attention to the strength to moderate, slow.

5, stick well, the radiator to exert some pressure, so that the thermal conductive silicone gasket can be fixed, while the fit more evenly, the heat dissipation effect will be better.