How to use thermal conductive silicone film correctly? The specific includes the following 7 steps, the specific by the thermal conductive silicone film manufacturers Cushion for you to analyze the introduction.

1. Keep the surface of thermal conductive silicone film clean to prevent the contamination of thermal conductive silicone film. The self-adhesive and sealing thermal conductivity of the dirt type thermal conductive silicone film will become poor.

2. When keeping the thermal conductive silicone film, the large thermal conductive silicone film should be grabbed from the center part without the smaller thermal conductive silicone film. Due to the uneven loading of the large heat-conducting silicone film, it will cause deformation and affect the subsequent operation, and even damage the silicone film.

3. Hold the sheet in your left hand and tear off one side of the protective film with your right hand. It can not tear both sides of the protective film at the same time, reducing the number and area of direct contact with the thermal conductive silicone film and keeping the self-adhesive and thermal conductivity of the thermal conductive silicone film from being damaged.

4. Tear off the side of the protective film, facing the heat sink. Align the thermal conductive silicone film with the heat sink. Slowly lower the thermally conductive silicone film. Be careful not to create air bubbles.

5. If air bubbles appear during operation, pull up the end of the silicone film to repeat the above steps, or use a tool to gently wipe out the air bubbles. The strength should not be too strong to avoid damaging the thermally conductive silicone film.

6. Tear off the other side of the protective film and put it into the heat sink, using less force to tear off the last layer of the protective film so as not to pull up or pull up the thermally conductive silicone film.

7. After tightening or using a strong adhesive thermal conductive silicone film, apply some pressure to the heat sink and store it for a period of time to ensure that the thermal conductive silicone film is properly secured.