How to clean the vulcanization dirt in silicone and rubber industrial molds has always been a headache. Because the vulcanization process of rubber and silicone needs to be completed under high temperature for a long time, resulting in some oil and chemical residues in the rubber material in the mold, forming stubborn dirt after high temperature coking.
In order to remove the stubborn dirt residue in the mold, often due to the general mold cleaning agent cleaning power is not enough, the cleaning process must be combined with a metal brush or sandblasting to remove the mold on the stubborn dirt, thus often causing serious damage to the surface of the mold.

The traditional silicone mold cleaning is to manually take the brush one by one, time-consuming and laborious, the fine seam is not clean, the following Cushion Electronics to recommend a simple to use method:.
Cleaning steps.
1、Prepare special silicone mold cleaning agent appropriate amount
2、Because the silicone material has strong adsorption ability, ultrasonic power needs to use the enhanced version, clean alliance ultrasonic PLUS enhanced series, very suitable for washing silicone mold, the lower the ultrasonic frequency the easier to produce cavitation effect, the greater the cleaning strength, the better the cleaning effect, choose 28KHZ frequency, can clean faster and cleaner.
3, the special cleaning agent will be heated to about 55 degrees as required, silicone molds immersed in the clean alliance ultrasonic equipment rough washing for about 10 minutes, it will be able to completely wash clean the stains on it.
4, depending on the actual need for 1-2 rinsing with water.
Follow Crestwood Electronics www.keshihua.comLearn more about silicone products!